 |
1.
PITTING AREA
Whole peaches are delivered
from the Merry-go-round to the Pitter through a feeder, then
transferred to the aligning section. Orientation begins
immediately and continues until the peach is transferred to the
pitting station. At this stage, the pit is oriented on the same
vertical and horizontal center lines of the twist mechanism. The
pit is held between two blades while a pneumatically activated
diaphragm envelopes each half of the fruit which rotates less
than on-half turn in opposite directions (counter-twisted). Once
the pitting cycle is completed, the two cleanly pitted halves
and the pit are discharged to a fluming system below the
machines. |
|
 |
|
Peach Torque Pitter
model CT800 The
Peach Torque Pitter model CT800 is designed to
feed, align and pit clingstone peaches. It offers pitting speeds of up to
82 peaches per minute. With the CT 800 you will not only
get high yelds, you will get a high quality end product
with improved pit cavity definition, less bruising and
fewer slivers. With the SELECTIVE KNIFE if the peach has
a split pit, it is identified prior to twisting and the
peach is selectively knife pitted during the normal
pitting cycle.
> view
more |
|
|
 |
| Peach
Pitter model 300-A
The Peach Pitter model 300-A is designed to automatically feed,
align and pit freestone and clingstone peaches at a rate
of up to 320 fruits per minute. Minimum rework is
required as a result of the knife pitting principle.
Near zero rework is required on freestone peaches even
during heavy split or stick-pit incidences. Superior
alignment efficiency, combined with gentle handling of
soft (pride) fruit results in the greatest possible
number of choice halves.
> view
more |
|
|
|
2.
REPITTING AREA
The flume discharges
the product into a Vibrating Pit Separator which allows the
loose pits to fall through a perforated screen. A Cup-Up
turnover orients all halves on an Inspection Belt with the pit
cavity up so fruit containing pit fragments can be removed and
conveyed to CTI FoodTech's Repitters for final pit removal. |
|
 |
|
Peach
Repitter model 6219 The
Peach Repitter model 6219 has been designed to feed,
align and repit freestone and clingstone peaches at
a rate of up to 320 half-peaches per minute. Thanks to
the automatic alignment system and to the knife repitting device, half-peaches require minimum working
time. The system assures high alignment efficiency,
guaranteeing gentle product management during the whole
working cycle.
>
view more |
|
|
|
|
